al
no_table_sensor
nts
Platesetter_3244
Disables the checking of the sensors on the Table_Tilt_Cylinder. The sensors
indicate cylinder extended and cylinder retracted. When nts=1 then the
firmware
will not check the position of the cylinder after causing it to move.
This parameter also works the same way for the Table_Stow_Cylinder.
Disables the checking of the sensors on the Table_Stow_Cylinder. The sensors
indicate cylinder extended and cylinder retracted. When nts=1 then the firmware
will not check the position of the cylinder after causing it to move.
nts=0 indicates sensor is installednts=1 indicates No sensor
integer
0
0 to 1
Table_Tilt_Cylinder tilts the table for load and unload.
Table_Stow_Cylinder together with Table_Tilt_Cylinder tilts the table to the
eject
position for feeding the plate into the conveyer.
If sensor disabled (nts=1), Firmware defaults to using time delay instead of
waiting for the cylinder extended (or retracted) sensor to become true.
timer: in milliseconds set by SET ALDLY TTILT. When the sensor is enabled a
timeout
error if generated is the cylinder extended (or retracted) sensor does not
become true
with in a certain time. The same value is used for timeout when sensor is
enabled.
cal